NINGBO TAI-LI A.E.T. CO., LTD 繁體中文版 简体中文版 English
Home|Contact us |Sitemap
Product Info
line
line
line
line
line
line
line
line
line
-
line
line
line
line
line
line
Support Info
 
HIMAX Electric Scredriver Operational Manuals
HIMAX Electric Scredriver Operational Ma
 
What's News
 
2019/07/22
Privacy and Cookie Policy

 

iconHomeiconProduct InfoiconFor Automatic Operation iconPOWER CONTROLLER CLT-50AT
Product Info
line
POWER CONTROLLER CLT-50AT
POWER CONTROLLER CLT-50AT
 
Power Controller CLT-50AT

For HIMAX TLF Series of Automation Electric Screwdriver
 
PDF Download Get Information Print|2019/12/03|View:9505
Specification

Operation instructions
1.This unit can be used to count the quantity of finished products and number of screws to be locked in a single product.
2.Make sure the input power and input signal are correct before use.
3.Press the key [PRE SET] to set the number of screws to be locked for finished products. The relevant value will be shown at [screw count display window].
4.Check the value at [finished product counting display window] to be confirmed by the user. For reset, you may press the key [CLEAR] (SW1/ON position).
5.Set the operation judge time for screw lock set (interval between two lock screws in the same work piece, (SW5/ON position). The fine cross head driver adjustment [GAP ADJ.] can be used at a time confirmed by the user (0.2~3.0 seconds).
6.In operation, each time receiving the signal from the lock brake of the screw control, the [SIGN] light of this unit will turn on, and the value at [screw count display window] will auto reduce by one (count down).
7.In continuous normal operation, when the value at [screw count display window] is reduced to zero, the value at [finished product counting display window] will auto increase by one, (At position SW4/ON, there will be beep sound) and the value at [screw count display window] will return to the preset value.
8.When the screw lock is poor and needs to re-operate, press the key [DEC.COU], the value at [screw count display window] will increase by one (until the preset value) (SW3/ON position).
9.When it is required to reset the lock screw number on the work piece to preset value, press the key [RESET] (SW2/ON position).

 
About Us | What's New | Product Info | Electric Screwdriver | Support | Contact Us | Sitemap
Copyright ©2008 NINGBO TAI-LI A.E.T. Tel: +86-574-87368178 Fax: +86-574-87368078 spaceCreated by Aboutnic